EasyKey Maker Honda Key Programmer Plus Toyota G and Toyota H Chip Vehicle Remote Key Programmer
EasyKey Maker Honda Key Programmer
Top reasons to buy EasyKeyMaker
1)Easy to use. Register keys full automatically. User just turns ignition ON/OFF.
2)Register keys fast. Finish registration in minutes.
3)Small package and easy to carry. Can be hold in one hand.
The device is for registering key by OBDII. Cover all Honda/Acura equipped with OBDII-16 socket. Support both transponder key and smart key registration in the following scenarios:
2)All keys lost
6)Replace smart entry
7)Replace key knob
1)Voltage & Current Requirements:8V – 18V DC (12V nominal) at 4 Amps (maximum)
3)Vehicle Connection: Molded DLC
4)Dimensions H:22mm (0.87in) W:54mm (2.13in) L:76mm (2.99in)
5)Weight: 50g (1.76oz)
6)Environmental Operating: -20ºC to 45ºC (-4ºF to 113ºF) at 15% to 85% RH non-condensing
Picture 2 3D view
1)Key Type Switch
IMMO: Transponder key
SMRT: Smart key
2)LED Status Indicators
OFF: Power OFF
ON: Power ON
* Long beep once "Di—" (Beep ON continuous for 3 seconds)
* Long beep periodically with "Di—"(Beep ON for 1 second and OFF for 1 second, and repeat)
* Short beep periodically with "Di" (Beep ON for 100 milliseconds, OFF for 900 milliseconds, and repeat)
* Short beep periodically with "Di, Di" (Beep ON for 100 milliseconds, OFF for 100 milliseconds, ON for 100 milliseconds, OFF for 700 milliseconds, and repeat)
* Short beep periodically with " Di, Di, Di" (Beep ON for 100 milliseconds, OFF for 100 milliseconds, ON for 100 milliseconds, OFF for 100 milliseconds, ON for 100 milliseconds, OFF for 500 milliseconds, and repeat)
Toyota G and Toyota H Chip Vehicle OBD Remote Key Programming Device
Apply to 4D67,68,72(G), support both G and H chip, It is tested on 2015 Camry successfully. More car modules will be tested and added.
Top 3 Reasons to get Toyota G and Toyota H Chip
1. For 4D67,68,72(G), support both G and H chip, test on 2015 Camry
2. Programm both Toyota G and Toyota H chip vehicle via OBD2 port.
3. Free shipping to all over the world.
5 steps to operate Toyota G and H chip OBD remote key programmer
Get in the car and close the door. Insert the original key and turn switch ignition to “ON” position.
Switch to “ADD TRANSPONDER” and insert the key programmer device into OBD connector. You will hear two beep sound (Dee-Dee), it will start to add the remote.
After two beep sound, you will hear continuously beep sound, the device indicator light will flash during the procedure.
After the sound (Dee- Dee-),open the door, when hear the sound blaring. Press “Lock & unlock” key at the same time. And press the “lock” key. If the blaring ends, it’s OK.
Insert the new transponder, no need to turn it, the indicator light will turn into flash.
The indicator will turn off after 60 seconds, then it’s done.
1pc x Toyota G and H OBD Remote Key Programmer
1pc x EasyKeyMaker Honda Key Programmer Brief Introduction
Original Autek IKey820 Key Programmer
If you have any questions, please feel free to contact us
WhatsApp: + 86 18205950686